Fronts for wardrobes
We also produce fronts for IKEA's wardrobe series Pax, however only the hinged doors. We produce fronts in all standard measurements IKEA also provide fronts in. We also produce fronts on a custom order, in case you need adjusted solutions that differ from the standard solutions. Custom sized fronts will come without hinge drillings, these will need to be made on site.
To increase stability and strength, we have added 1 more hinge drilling to our doors compared to the IKEA ones. This extra drilling is placed in the top half of the doors to avoid any challenges when installing drawers in the bottom half of the cabinetMost of our series can be used for this, except the following:
- CHELSEA brass (cannot be made over 199,7 cm in height)
- SURFACE metal (cannot be made for doors over 140 cm)
- FOLD (cannot be made for doors over 140 cm)
- UP (cannot be made for doors over 140 cm)
- PROFILE (only available for kitchen cabinets)
We don't suggest hanging your wardrobe cabinets on the wall, unless you have been advised to do so from a professional installer.
The shallow PAX cabinets are suited to hang on the wall if the wall is strong enough. Then cut the plinth part off the PAX wardrobe and we will order the doors to fit the cabinet without plinth.
We also offer different solutions to your wardrobe fronts regarding handle placements and if the door should cover the plinth or not. If you have visible sides of your wardrobe, we also offer coverpanels in the selected design, as well as plinths.